400 F self lubricating oscillating bushing
400 F self lubricating oscillating bushing
(OP)
We have an application in a coal pulverizer where a ~ 7 inch diameter steel shaft oscillates a little. Normal operation is a probably a good bit less than 400 F, but it may have to endure an occasional fire.
Potential for edge loading is high
Does anyone have a success story to share?
thanks
Dan T
Potential for edge loading is high
Does anyone have a success story to share?
thanks
Dan T





RE: 400 F self lubricating oscillating bushing
Mike Halloran
Pembroke Pines, FL, USA