NX 6.0 Weld symbols
NX 6.0 Weld symbols
(OP)
Morning Chaps,
Just a quick question I hope:
I have put in a weld symbol onto a drawing, and it doesn't look right to me (or the checker). My issue is with the flat/convex symbol above the weld type - it looks too far away/misaligned.
It isn't a show stopper, but thought I would ask the question on here.
See attached pic or my drawing:

And pic of what I am aiming to achieve from BS22553:1994:

Cheers
Tom
Just a quick question I hope:
I have put in a weld symbol onto a drawing, and it doesn't look right to me (or the checker). My issue is with the flat/convex symbol above the weld type - it looks too far away/misaligned.
It isn't a show stopper, but thought I would ask the question on here.
See attached pic or my drawing:
And pic of what I am aiming to achieve from BS22553:1994:
Cheers
Tom





RE: NX 6.0 Weld symbols
RE: NX 6.0 Weld symbols
RE: NX 6.0 Weld symbols
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 6.0 Weld symbols
Will have to tell the checker that's just the way it is for now then.