How to change dimension associativity
How to change dimension associativity
(OP)
Hi,
It's a very basic question in drafting (NX7.5) but I can't remember
How to break the link between dimension in Chain dimension ?

Thanks in advance
It's a very basic question in drafting (NX7.5) but I can't remember
How to break the link between dimension in Chain dimension ?

Thanks in advance
Regards
Didier Psaltopoulos
http://www.psi-cad.com





RE: How to change dimension associativity
then edit associativity
RE: How to change dimension associativity
I was not clear in the tittle. It's not the associativity but the position
Regards
Didier Psaltopoulos
http://www.psi-cad.com
RE: How to change dimension associativity
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.