Amada A3000D with 160I-l Controller STUCK after auto age
Amada A3000D with 160I-l Controller STUCK after auto age
(OP)
Hello everyone
We purchased a used Amada Laser /LC-2415/160i-l
We have had no problems but after starting up yesterday the laser would Auto Age and freeze at sequence 20,(After the normal wait period at seq 28). I was wondering if you guys had any thought on what could cause this problem. The laser was down for about 4 days so we figured on a longer than normal auto age time.
'
Thanks in advance
Ken
We purchased a used Amada Laser /LC-2415/160i-l
We have had no problems but after starting up yesterday the laser would Auto Age and freeze at sequence 20,(After the normal wait period at seq 28). I was wondering if you guys had any thought on what could cause this problem. The laser was down for about 4 days so we figured on a longer than normal auto age time.
'
Thanks in advance
Ken





RE: Amada A3000D with 160I-l Controller STUCK after auto age
RE: Amada A3000D with 160I-l Controller STUCK after auto age
Ken