Opening NX parts in ANSA
Opening NX parts in ANSA
(OP)
Does anyone have experience with ANSA's NX translator? I'm trying to figure out how data and attributes are recognized in ANSA.
I think ANSA translates what ever was visible when the NX part was saved. If a midsurface was saved on layer 10, then layer 10 needs to be visible when the part is saved if you expect to see it in ANSA.
I noticed ANSA was able to open assemblies too. I created a "midsurface" reference set in each part so that I could save my assembly with it visible. I'm stating this because I'm wondering if there's a better method.
Also, I would like to have my material thickness attribute be recognized but have been unable to figure this out so far.
I think ANSA translates what ever was visible when the NX part was saved. If a midsurface was saved on layer 10, then layer 10 needs to be visible when the part is saved if you expect to see it in ANSA.
I noticed ANSA was able to open assemblies too. I created a "midsurface" reference set in each part so that I could save my assembly with it visible. I'm stating this because I'm wondering if there's a better method.
Also, I would like to have my material thickness attribute be recognized but have been unable to figure this out so far.




