SPRING design in NX
SPRING design in NX
(OP)
Hi,
I haven't ever design a spring with this profile.
How would you create it?....
The dimension could be flexible(in value or units, mm/inch); the only requirement is to keep the shape from attachment as close as possible.
Thanks!
I haven't ever design a spring with this profile.
How would you create it?....
The dimension could be flexible(in value or units, mm/inch); the only requirement is to keep the shape from attachment as close as possible.
Thanks!
MZ7DYJ





RE: SPRING design in NX
MZ7DYJ
RE: SPRING design in NX
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: SPRING design in NX
I was wondering if you could teach us to create the spring in NX 9.0.
Just a regular 3D design, no "Deformable Component" task needed...................
Thanks!
MZ7DYJ
RE: SPRING design in NX
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: SPRING design in NX
I look forward to see your project.
MZ7DYJ
RE: SPRING design in NX
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: SPRING design in NX
MZ7DYJ