Cross-section creation aborted
Cross-section creation aborted
(OP)
I am trying to make a section view of an assembly. I have 2 sections views which were created in the model. Section A is going thru a certain feature and Section B is going thru the Right Datum plane which is the center of the assembly. I go to the drawing and try entering in Section A and it just looks like a standard side view and I get a message saying:
Cross-section creation in view "right_12", on sheet 1, aborted.
What am I doing wrong?
Cross-section creation in view "right_12", on sheet 1, aborted.
What am I doing wrong?





RE: Cross-section creation aborted
----------------------------------------
The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
RE: Cross-section creation aborted