Sketch point display size
Sketch point display size
(OP)
Is there any way to alter the display size of sketch points in NX9? Searched preferences and customer defaults but nothing...
They are really too small to work with. Even the constrain symbol sizes seem to be customizable in the defaults so I hope that I'm just missing the setting.
Any help would be appreciated
They are really too small to work with. Even the constrain symbol sizes seem to be customizable in the defaults so I hope that I'm just missing the setting.
Any help would be appreciated





RE: Sketch point display size
However this will increase the size of the WCS and View triads (can't remember the other things it affects).
Anthony Galante

Senior Support Engineer
NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3.4
NX8.5.0.23 -> NX8.5.2.3 & NX9.0.0.19
RE: Sketch point display size
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Sketch point display size