simple Section Line FONT change
simple Section Line FONT change
(OP)
people,
I am busy working away on a complex detail drawing in NX7.5.5.4 MP3, many sections needed
all going OK until i opened the drawing and the section lines for the SECTION cuts have changed their FONT to SOLID,
not our standard and i am not able to find how to get the broken line back
we do run thru TeamCentre ( not sure if that is relevant )
any ideas on how to fix this back again .
thanks i advance ............ Gary
I am busy working away on a complex detail drawing in NX7.5.5.4 MP3, many sections needed
all going OK until i opened the drawing and the section lines for the SECTION cuts have changed their FONT to SOLID,
not our standard and i am not able to find how to get the broken line back
we do run thru TeamCentre ( not sure if that is relevant )
any ideas on how to fix this back again .
thanks i advance ............ Gary





RE: simple Section Line FONT change
Preferences -> Visualization -> Line
...and at the top of the page change the 'Line Font Display' option from 'Hardware' to 'Software' and hit OK. If the Section Line symbol is still solid, it's not the Hardware, but if you reach this point, I haven't the vaguest idea what's causing this or how to go about fixing it.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.