Mesh-to-Geometry Abaqus 6.13
Mesh-to-Geometry Abaqus 6.13
(OP)
Hi,
I would like to use the geometry of a deformed mesh in a new analysis.
In Abaqus 6.13 there should be a tool to do this. However, I cannot find this tool in the programme.
Does anybody know where this feature is hided?
Thanks!
I would like to use the geometry of a deformed mesh in a new analysis.
In Abaqus 6.13 there should be a tool to do this. However, I cannot find this tool in the programme.
Does anybody know where this feature is hided?
Thanks!





RE: Mesh-to-Geometry Abaqus 6.13
I'm pretty sure that the tool you referred to is the "3D Mesh to Geometry" plug-in that is advertised here:
http://www.3ds.com/products-services/simulia/portf...
I may be wrong but I think this plug-in must be purchased from the Simulia BENELUX office.
You should contact them and ask.
Regards,
Dave
RE: Mesh-to-Geometry Abaqus 6.13
I saw that plug-in, but I recently upgraded from 6.12 to 6.13 and thought that 6.13 had this already build-in.
I've read this on websites. http://www.exemplar.com/index.php?/ln/it/id_p/8/id... and a similar Dutch website.
Maybe they indeed mean the plug-in...
Thanks again!