Anyone have the old Dudley articles?
Anyone have the old Dudley articles?
(OP)
I am looking for these two articles by Darle W. Dudley. I have looked everywhere and cannot find these. If anyone has a copy of them please let me know. I would be more than willing to pay for them.
"When Splines need stress Control" by Darle W. Dudley
Product Engineering 12/23/57
"How to design Involute Splines by Darle W. Dudley
Product Engineering 10/28/87
"When Splines need stress Control" by Darle W. Dudley
Product Engineering 12/23/57
"How to design Involute Splines by Darle W. Dudley
Product Engineering 10/28/87





RE: Anyone have the old Dudley articles?
Is there some particular bit of information in these articles about spline design that you wish to know? I've read the older article by Dudley, and while it provides some good general guidance for designing splines, it is also a bit dated.
RE: Anyone have the old Dudley articles?
RE: Anyone have the old Dudley articles?
israelkk, the full articles are in the book? Or is some of the information just listed in the book? I will have to look into it.
RE: Anyone have the old Dudley articles?
RE: Anyone have the old Dudley articles?
The equations shown in Machinery's Handbook for calculating spline loads are derived from Dudley's article.
The on-line calculator via this link is also based on Dudley's article - http://www.zakgear.com/External_Spline_IN.html
Ron Volmershausen
Brunkerville Engineering
Newcastle Australia
http://www.aussieweb.com.au/email.aspx?id=1194181
RE: Anyone have the old Dudley articles?