Coordinate System not transferred to post-processor
Coordinate System not transferred to post-processor
(OP)
Hello all,
I have an analysis of a model created in a rectangular coordinate system. However, I want to see the radial stresses at some point. This is why I created a datum CSYS.
In the results visualization mode, when I go to Tools -> Coordinate System and Selecting as Data Source the Current ODB I cannot see my datum csys.
Any idea on how to transfer it in results mode?
Thank you very much.
I have an analysis of a model created in a rectangular coordinate system. However, I want to see the radial stresses at some point. This is why I created a datum CSYS.
In the results visualization mode, when I go to Tools -> Coordinate System and Selecting as Data Source the Current ODB I cannot see my datum csys.
Any idea on how to transfer it in results mode?
Thank you very much.





RE: Coordinate System not transferred to post-processor
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083