simple extrude between 2 differet diameters
simple extrude between 2 differet diameters
(OP)
people,
this has got to be simple but i am making hard work of
sweeping, extruding a solid ? between to circles of different diameters on either end of a curving spline
any pointers ..
regards . gary
Nx7.5 on WIN7 OS64
this has got to be simple but i am making hard work of
sweeping, extruding a solid ? between to circles of different diameters on either end of a curving spline
any pointers ..
regards . gary
Nx7.5 on WIN7 OS64





RE: simple extrude between 2 differet diameters
Insert -> Sweep -> Swept...
...and just select each arc as the start and end Sections, and the spline as the single Guide, as I did in the sample file attached below.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: simple extrude between 2 differet diameters
worked perfectly, the attached .PRT was invaluable,
regards ... gary