[NX 8.5] Orient View to Face
[NX 8.5] Orient View to Face
(OP)
Hello All,
I'm looking for the command or workflow to orient the graphics window view to a specified face. I know snap-fit (F8) will orient the view to the coordinate planes, but I want to orient to an angled face, that isn't on a coordinate plane.
Is there a command for this?
Thanks
I'm looking for the command or workflow to orient the graphics window view to a specified face. I know snap-fit (F8) will orient the view to the coordinate planes, but I want to orient to an angled face, that isn't on a coordinate plane.
Is there a command for this?
Thanks
- Justin Heckman





RE: [NX 8.5] Orient View to Face
www.nxjournaling.com
RE: [NX 8.5] Orient View to Face
Thanks again @cowski
- Justin Heckman
RE: [NX 8.5] Orient View to Face