OM Object
OM Object
(OP)
I have a part with a problem
I run NX 7.5.5.4 whit TC 8.3
When i want to make a part display part i get the message:
xxxxxxx\A An operation was attempted on an invalid or unsuitable OM object
I have read in the forum to contact GTAC. that's also wat i'm going to do.
Butt my question for here is what is a OM Object?
Does anyone know this?
Ruud
I run NX 7.5.5.4 whit TC 8.3
When i want to make a part display part i get the message:
xxxxxxx\A An operation was attempted on an invalid or unsuitable OM object
I have read in the forum to contact GTAC. that's also wat i'm going to do.
Butt my question for here is what is a OM Object?
Does anyone know this?
Ruud





RE: OM Object
I don't have much TC knowledge but it could be Object Master.
Regards
Kapil
RE: OM Object
1) Call GTAC and be prepared to send them the file.
2) Run Part Cleanup and see if that helps.
3) Run UG_Inspect on the file.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli