how to extract stress-strain data for non linear tensile simulation from ABAQUS
how to extract stress-strain data for non linear tensile simulation from ABAQUS
(OP)
I am new in FEA using ABAQUS.I have done a non linear tensile simulation of a dog bone specimen. But could not find way to extract data for stress n strain. How to get these data? what steps in ABAQUS can give me these information?
thanks
thanks





RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
Quando Omni Flunkus Moritati
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
Quando Omni Flunkus Moritati
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
Quando Omni Flunkus Moritati
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
RE: how to extract stress-strain data for non linear tensile simulation from ABAQUS
i'll assume your group od elements represents a cross-section of the model. so wouldn't the load be the applied load (and the average stress = P/A) ? or are you just checking to see if the FEA is producing correct results?
Quando Omni Flunkus Moritati