NX6 crashing when I move toolbar
NX6 crashing when I move toolbar
(OP)
thread561-302787: ug nx 6.0.5.3 mp1 64 bit freezes when I move toolbars
I know there have been some posts on this topic awhile ago but this problem still persists. I was running NX6 on a windows XP workstation last week but today I got a brand new windows 7 64bit workstation. After reading the other posts on this, I removed IE (was IE 11) but that did not fix it. Is there anything else I could try?
I know there have been some posts on this topic awhile ago but this problem still persists. I was running NX6 on a windows XP workstation last week but today I got a brand new windows 7 64bit workstation. After reading the other posts on this, I removed IE (was IE 11) but that did not fix it. Is there anything else I could try?





RE: NX6 crashing when I move toolbar
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.