How can I apply seismic load at my reference plane center of mass?
How can I apply seismic load at my reference plane center of mass?
(OP)
Hi all,
I treat my mezz. floor level as reference plan and assigned a rigid diaphragm, then I want to apply my seismic load of mezz floor at its center of mass, but ETABS would not allow me to do it since ETABS assumed mezz is a reference floor, I guess. Any solution for this issue? Thanks in advance.
I treat my mezz. floor level as reference plan and assigned a rigid diaphragm, then I want to apply my seismic load of mezz floor at its center of mass, but ETABS would not allow me to do it since ETABS assumed mezz is a reference floor, I guess. Any solution for this issue? Thanks in advance.





RE: How can I apply seismic load at my reference plane center of mass?
Analysis and Design of arbitrary cross sections
Reinforcement design to all major codes
Moment Curvature analysis
http://www.engissol.com/cross-section-analysis-des...
RE: How can I apply seismic load at my reference plane center of mass?