nx 8 will not open any parts
nx 8 will not open any parts
(OP)
Nx 8 worked fine yesterday, this morning i get this error. An attempt was made to set a constrained attribute to a value outside its limits.
after that memory access violations on any part i attempt to open.
I can not open any parts.
Anyone have any ideas?
after that memory access violations on any part i attempt to open.
I can not open any parts.
Anyone have any ideas?





RE: nx 8 will not open any parts
www.nxjournaling.com
RE: nx 8 will not open any parts
Run Ug_inspect on your part(s).
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli