Dart bug?
Dart bug?
(OP)
Hello.
I think the dart command doesn't work well if you choose the angle to be equal to 0º (that's parallel walls), you can choose any other angle but not zero.
I've seen the same problem in NX 8.5 and NX 6.0.
Regards
I think the dart command doesn't work well if you choose the angle to be equal to 0º (that's parallel walls), you can choose any other angle but not zero.
I've seen the same problem in NX 8.5 and NX 6.0.
Regards





RE: Dart bug?
www.nxjournaling.com
RE: Dart bug?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Dart bug?