NX8.5 3dconnexion spaceball rotation reference
NX8.5 3dconnexion spaceball rotation reference
(OP)
Going from NX7.5 at JCB to NX8.5 at Aston Martin the spaceball seems to behave differently in that its not updating the rotation reference to the geometry in view. Im constantly having to set rotation reference when examining components in assemblies, I dont recall having to do that in NX7.5, has something changed going to 8.5 or could it be the spaceball driver?
system info - NX8.5.1.3, 3DConnexion driver 6.17.6
Any help appreciated.
system info - NX8.5.1.3, 3DConnexion driver 6.17.6
Any help appreciated.
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5





RE: NX8.5 3dconnexion spaceball rotation reference
As for setting a specific point of rotation relative to a point on the model/assembly, that pretty much works like it always did except that we've now preprogrammed a pair of control keys to enable/disable this specific point of roation, Ctrl+F2 to set the point and Ctrl+F3 to unset it.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8.5 3dconnexion spaceball rotation reference
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5
RE: NX8.5 3dconnexion spaceball rotation reference
I hope this helps.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8.5 3dconnexion spaceball rotation reference
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5
RE: NX8.5 3dconnexion spaceball rotation reference
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.