PD5500 Conical Ends Greater than 60¦
PD5500 Conical Ends Greater than 60¦
(OP)
Hi All,
I was just wondering what rules to design too if my conical end half angle at the apex is greater than 60° as stated in PD5500.
If there's anything in PD5500 that's great if not i would be happy to look at other codes.
Best Regards
Jonno
I was just wondering what rules to design too if my conical end half angle at the apex is greater than 60° as stated in PD5500.
If there's anything in PD5500 that's great if not i would be happy to look at other codes.
Best Regards
Jonno





RE: PD5500 Conical Ends Greater than 60¦