Unbend Buried feature in check mate
Unbend Buried feature in check mate
(OP)
Hello all,
i have a question, When i want to make a normal cutout in a sheetmetal part (see image) i preform a unbend an after the cutout a rebend
No i will get the following problem: when an run a checkmate after this a get a not allowed buried feature (the unbend)
How can i get this throw the check?
Ruud[img ]
i have a question, When i want to make a normal cutout in a sheetmetal part (see image) i preform a unbend an after the cutout a rebend
No i will get the following problem: when an run a checkmate after this a get a not allowed buried feature (the unbend)
How can i get this throw the check?
Ruud[img ]





RE: Unbend Buried feature in check mate
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Unbend Buried feature in check mate
RE: Unbend Buried feature in check mate
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.