Drafting with our company standards
Drafting with our company standards
(OP)
I’m new to NX and now started detailing a design done outside.
I’ve made Drafting templates with our company standards and would like to appear this standards in the drawings I create. We use non-master model concept (i.e.: Drawing reside in the part file, and therefore I believe that original part standards supersedes our company drw standards).
After bringing the views in to the drawing sheet, do I have to reload our standards manually for each and every drawing? If I have to, how can I automate it? (Run a macro with template open?)
I’ve made Drafting templates with our company standards and would like to appear this standards in the drawings I create. We use non-master model concept (i.e.: Drawing reside in the part file, and therefore I believe that original part standards supersedes our company drw standards).
After bringing the views in to the drawing sheet, do I have to reload our standards manually for each and every drawing? If I have to, how can I automate it? (Run a macro with template open?)
Michael Fernando (CSWE)
www.solidCADworks.com
Tool and Die Designer
Siemens NX V8.5 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks





RE: Drafting with our company standards
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Drafting with our company standards
Michael Fernando (CSWE)
www.solidCADworks.com
Tool and Die Designer
Siemens NX V8.5 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks
RE: Drafting with our company standards
RE: Drafting with our company standards
RE: Drafting with our company standards