Smart lightweight view in NX8.5 and over
Smart lightweight view in NX8.5 and over
(OP)
I'm testing NX9 before to switch all compartments to NX9 and I'm look to the new smart lightweight views.
A part to use with big assembly drawings, can the idea to use this setting very often for single parts or little assembly wrong ?
Which limitations are to use this setting to improve performance drawing in general ?
If the idea isn't wrong, how can resolve situation like the PDF attached ?
A part to use with big assembly drawings, can the idea to use this setting very often for single parts or little assembly wrong ?
Which limitations are to use this setting to improve performance drawing in general ?
If the idea isn't wrong, how can resolve situation like the PDF attached ?
Thank you...
Using NX 8 and TC9.1




