Help please
Help please
(OP)
HI guys, am completely new top solid edge. So i am looking for some sort of help.
i am trying to create a cutout in sheet metal mode.
i have a flage and have text written on it, all i want to create a cutout of the text.
i am stuck here, seem to be something simple which i am missing out, but as i told you i am new to solid edge so trying to learn
please help me.
also i am using solid edge st 6
Sam
i am trying to create a cutout in sheet metal mode.
i have a flage and have text written on it, all i want to create a cutout of the text.
i am stuck here, seem to be something simple which i am missing out, but as i told you i am new to solid edge so trying to learn
please help me.
also i am using solid edge st 6
Sam





RE: Help please
And the proper font should be Stencil.
Are you trying to do a text cutout over the bend?
RE: Help please
If you are using a font like Solid Edge ISO, you will get multi body part. All those letters like 'o', 'd' and similar will create another body. And because of that, you will have problems rebending such sheet metal model. Actually, you will not be able to rebend it.
But, if you use a Stencil font, then there will be no such problem. As you can also see in the movie.
Hope it helps.
RE: Help please
Ken G.
http://grundey.blogspot.com
Have you checked out the Solid Edge Community site?
http://community.plm.automation.siemens.com/t5/Sol...