Material selection for hydrotreater/hydrocracker reactors
Material selection for hydrotreater/hydrocracker reactors
(OP)
Dear all,
Normally, 1.25 Cr-0.5 Mo or 2.25Cr-1Mo is selected for this service based on Nelson curves for the service.
However, can 300 series SS be used ? If yes, what shall be selected ? 304, 304L, 321, 347 ? what are the problem of using SS ?
Normally, 1.25 Cr-0.5 Mo or 2.25Cr-1Mo is selected for this service based on Nelson curves for the service.
However, can 300 series SS be used ? If yes, what shall be selected ? 304, 304L, 321, 347 ? what are the problem of using SS ?





RE: Material selection for hydrotreater/hydrocracker reactors
RE: Material selection for hydrotreater/hydrocracker reactors
Steve Jones
Corrosion Management Consultant
http://www.linkedin.com/pub/8/83b/b04
All answers are personal opinions only and are in no way connected with any employer.
RE: Material selection for hydrotreater/hydrocracker reactors