View Projection Question
View Projection Question
(OP)
RE: Y14.3 MULTIVIEW AND SECTIONAL VIEW DRAWINGS
(I had tacked this question onto the end of another thread, but feel it needs better visibility)
Is an orthographic projected view from a section view (full, half or partial) allowed? The standard addresses taking a section from a section, but that's about it. I am struggling to find support in the standard for prohiting such views as this goes against what I was taught, but this practice is very common where I work (the "DRM" already takes exception to the section-from-section rule). I feel I am going to lose this argument without a documented source prohibiting this practice.
TIA!
(I had tacked this question onto the end of another thread, but feel it needs better visibility)
Is an orthographic projected view from a section view (full, half or partial) allowed? The standard addresses taking a section from a section, but that's about it. I am struggling to find support in the standard for prohiting such views as this goes against what I was taught, but this practice is very common where I work (the "DRM" already takes exception to the section-from-section rule). I feel I am going to lose this argument without a documented source prohibiting this practice.
TIA!
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV





RE: View Projection Question
RE: View Projection Question
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV
RE: View Projection Question
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV
RE: View Projection Question
What is Engineering anyway: FAQ1088-1484: In layman terms, what is "engineering"?
RE: View Projection Question
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV
RE: View Projection Question
Back in my time (I am old) we entertained the idea of the "main view", the one that conveys the most information about the part.
And replacing this view with section to provide even more information was appropriate.
I guess today it's more of a matter of what your CAD software can do and common sense.
RE: View Projection Question
RE: View Projection Question
My opinion of disallowing them is based on an "extension of principal" where a section from a section is not allowed. Since our DRM does allow this, I must concede that a projection from a section should also be allowed.
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV