Can't save NX part file
Can't save NX part file
(OP)
When i am trying to save a prt file, i get the error message:
"-Modeler error: unexpected file-access error from Frustrum".
If anybody knows how to fix this i would be very thankfull.
-Andreas
"-Modeler error: unexpected file-access error from Frustrum".
If anybody knows how to fix this i would be very thankfull.
-Andreas





RE: Can't save NX part file
If that doesn't work, contact GTAC.
If you don't have support, get it. You paid a lot for the SW, the cost of support is cheap after that.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli