Constraining sketch profile to a fixed over all length, NX9
Constraining sketch profile to a fixed over all length, NX9
(OP)
Pretty sure I used to able to do this in NX 7 - 8 but I don't see it in Version 8.5 or 9
From with in the Sketch Env, you could constrain the length of a curve, or set of connected curves, to an associative measurement.
Am I missing something?
TIA
Dave
From with in the Sketch Env, you could constrain the length of a curve, or set of connected curves, to an associative measurement.
Am I missing something?
TIA
Dave





RE: Constraining sketch profile to a fixed over all length, NX9