Splines
Splines
(OP)
Is there any common sizes or nominal dimensions for splines? Is an Involuted spline the optimum design for a spline? Is there any websites have information on splines that may be helpful?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Splines
RE: Splines
, I use it often.
http://www.omnigearandmachine.com/technical_information.htm
Pardal
RE: Splines
Splines ARE standardized.
Here are some involute spline standards:
ISO4156, DIN5480, ANSI B92.2M (all metric, module based splines; metric spline standards are practically all the same) or ANSI B92.1 (US,inch, diametral pitch based standard).
gearguru
RE: Splines
The alternative is expensive: precision outer part mating with precision inner part with all the tolerancing challenges that go with it.
RE: Splines
RE: Splines