Quantity on part drawing
Quantity on part drawing
(OP)
Hello,
is it possible to shown the quantity in the Part Drawing?
The problem is our tool shop needs the quantity on the part drawing and not only on the part list.
We have the part list in the top assembly and from there we need the quantity to be write back in the single part so we can show it in the drawing.
Our parts are all unique and will only assembled in one assembly.
is it possible to shown the quantity in the Part Drawing?
The problem is our tool shop needs the quantity on the part drawing and not only on the part list.
We have the part list in the top assembly and from there we need the quantity to be write back in the single part so we can show it in the drawing.
Our parts are all unique and will only assembled in one assembly.





RE: Quantity on part drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Quantity on part drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Quantity on part drawing
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Quantity on part drawing
“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV
RE: Quantity on part drawing
Below is a link to a similar discussion from a few years ago (but with no real resolution)
thread561-267187: QUANTITY ATTRIBUTE DRIVEN BY PARENT ASSEMBLY?
www.nxjournaling.com
RE: Quantity on part drawing
And this is a usual workflow in toolshops, because the drawings of the complete tool will go in different departments or will be manufactured external, and we can´t give everyone a part list.
We use this method (quantitiy on the detail drawing) in all our systems (2D-Software/ 3D-Software Solidworks/Visi) only in NX it doesn`t work.
RE: Quantity on part drawing
http://www.amazon.com/Engineering-Documentation-Co...
www.nxjournaling.com