Delete part list, delete balloons
Delete part list, delete balloons
(OP)
Hi,
on NX 7, after deleting a part list, balloons aren't deleted.
On NX 8, after deleting a part list, balloons are deleted.
This is as expected as NX 8 implementation or is a setting that on the switch I missed ?
on NX 7, after deleting a part list, balloons aren't deleted.
On NX 8, after deleting a part list, balloons are deleted.
This is as expected as NX 8 implementation or is a setting that on the switch I missed ?
Thank you...
Using NX 8 and TC9.1





RE: Delete part list, delete balloons
I went back as far as NX 5.0 and in all cases I tested, when I deleted the Parts List object, the associated ID balloons were also deleted.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Delete part list, delete balloons
Sure....
Thank you...
Using NX 8 and TC9.1
RE: Delete part list, delete balloons
Thank you...
Using NX 8 and TC9.1