How to show stamped "PATENT PENDING" wording on a SW part?
How to show stamped "PATENT PENDING" wording on a SW part?
(OP)
I'm trying to indent the words PATENT PENDING on a part. The parts surface is not flat, but curved (radius). Is ther a way to "carve the words into the part? I want the part to show the wording. I'm in SW11. I'm a Proe guy but this job is SW. Anyone out there?






RE: How to show stamped "PATENT PENDING" wording on a SW part?
RE: How to show stamped "PATENT PENDING" wording on a SW part?
Attached image took about a minute to create a picture in paint that said Patent Pending,
Photview>Edit Decal>Select Geometry and so on. A tutorial with a full walk through should be easy to find.
RE: How to show stamped "PATENT PENDING" wording on a SW part?
- - -Updraft