How to connect/add/Model an end plate with steel box beam in ABAQUS 6.11
How to connect/add/Model an end plate with steel box beam in ABAQUS 6.11
(OP)
Hello,
Please help me by telling step by step procedure for how to add/connect/draw an end plate with 60mmx120mmx10mm with an already modelled sheel box beam. I shall be thankful for a step by step procedure in Abaqus 6.11.
Please help me by telling step by step procedure for how to add/connect/draw an end plate with 60mmx120mmx10mm with an already modelled sheel box beam. I shall be thankful for a step by step procedure in Abaqus 6.11.





RE: How to connect/add/Model an end plate with steel box beam in ABAQUS 6.11
Analysis and Design of arbitrary cross sections
Reinforcement design to all major codes
Moment Curvature analysis
http://www.engissol.com/cross-section-analysis-des...
RE: How to connect/add/Model an end plate with steel box beam in ABAQUS 6.11