PART DISPLAY PROBLEM IN NX8
PART DISPLAY PROBLEM IN NX8
(OP)
Hi,
I am facing a display problem with the parts in NX. so the parts appear like as if they are scattered.it makes very odd when i am in design meeting
Please find the image. and tell me any settings ??
thanks in advance
I am using Nx8
Thx
Pat.
I am facing a display problem with the parts in NX. so the parts appear like as if they are scattered.it makes very odd when i am in design meeting
Please find the image. and tell me any settings ??
thanks in advance
I am using Nx8
Thx
Pat.





RE: PART DISPLAY PROBLEM IN NX8
Try putting of the option Highlight Original (Preferences/Selection/Highlight Original). Sorry i don't have NX8 installed with me and i have a little doubt when was this option brought inside NX (NX8 or NX8.5).But still worth giving a try.
Best Regards
Kapil Sharma
RE: PART DISPLAY PROBLEM IN NX8
It , to me , looks like a graphics driver / graphics adapter problem.
Is the computer on the Siemens Certified list ?
does it have a certified graphics card ? - The certified driver ?
see:
http://support.industrysoftware.automation.siemens...
Regards,
Tomas