exporting from catia v5 to nx 7.5
exporting from catia v5 to nx 7.5
(OP)
Hello Everyone,
I am trying to export catia v5 models to NX 7.5. I believe this should be very simple. If someone can give me a simple step by step solution it would be greatly appreciated
I am trying to export catia v5 models to NX 7.5. I believe this should be very simple. If someone can give me a simple step by step solution it would be greatly appreciated





RE: exporting from catia v5 to nx 7.5
Regards
Fernando
https://picasaweb.google.com/102257836106335725208
https://picasaweb.google.com/103462806772634246699...
RE: exporting from catia v5 to nx 7.5
I know there are a variety of different Catia to NX translators that can bring different amounts of information over to NX but they vary in cost and some are very expensive.
Tim Banks
Application Engineer
VMH International
NX 8.5 / Solid Edge ST6
RE: exporting from catia v5 to nx 7.5
If not use STEP conversion in Catia and then open in NX.
Nx 7.5.5.4
Teamcenter 8