Tables in drafting.
Tables in drafting.
(OP)
When I insert a table to be used to make a custom title bar I would like to know how I can move the table using snaps so
that I can snap to the border in the lowwer right corner instead of just moving it in place by eye close to where I want it to be.
Any suggestions welcome, maybe it is something small I am overlooking.Move cannot snap the move icon to to endpoints of the table in order to move it accuratly
Thanks nx8
B.
that I can snap to the border in the lowwer right corner instead of just moving it in place by eye close to where I want it to be.
Any suggestions welcome, maybe it is something small I am overlooking.Move cannot snap the move icon to to endpoints of the table in order to move it accuratly
Thanks nx8
B.





RE: Tables in drafting.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Tables in drafting.
pick Origin from the menu
pick the top-right icon (point constructor) in the Origin Tool menu, but first toggle associative if that's want you want
In the Origin Location pull-down menu, pick what you want