Move Object - Dynamic - NX8.0.0
Move Object - Dynamic - NX8.0.0
(OP)
Hello,
Referencing below thread...... Move Object in NX8.0.0.25, I can't seem to find "Snap handles to WCS" during dynamic positioning. What the cube was in the referenced thread is a sphere now and a mouse over tip pops up "Translate Origin". I see no reference or option to re-orient the handles rather than just reposition the origin.
eng-tips.300447
Thanks,
Kevin
Referencing below thread...... Move Object in NX8.0.0.25, I can't seem to find "Snap handles to WCS" during dynamic positioning. What the cube was in the referenced thread is a sphere now and a mouse over tip pops up "Translate Origin". I see no reference or option to re-orient the handles rather than just reposition the origin.
eng-tips.300447
Thanks,
Kevin





RE: Move Object - Dynamic - NX8.0.0
www.nxjournaling.com
RE: Move Object - Dynamic - NX8.0.0
What version are you running?
Thanks for lookin'
Kevin
RE: Move Object - Dynamic - NX8.0.0
www.nxjournaling.com
RE: Move Object - Dynamic - NX8.0.0
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Move Object - Dynamic - NX8.0.0
RE: Move Object - Dynamic - NX8.0.0
Thanks,
Kevin