I have a sub assembly of a sliding rail which I use for slide-out drawers and the like. When I create an assembly of a drawer, I use (2) sliding rails. My drawer assembly BOM will show (2) rails. Since they are purchased in pairs I'd like the BOM to show a quantity of (1) instead. Is there a way for me to change the "Unit Quantity" for each rail sub assembly to a value of "0.5"?
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
When was the last time you drove down the highway without seeing a commercial truck hauling goods?The ubiquity of these machines underscores the important roll they play in modern commerce. Download Now