nx8 drafting question
nx8 drafting question
(OP)
I Don't do much drafting but I have a question. When dimensioning and settings are set to a 3 place decimal (1.000) if the actual number is 1.0005 shouldn't
the output be 1.001? is this a setting to force round up? I get 1.000.
Thanks
the output be 1.001? is this a setting to force round up? I get 1.000.
Thanks





RE: nx8 drafting question
thread561-197969: Drafting dimensions rounding up/down
www.nxjournaling.com
RE: nx8 drafting question
RE: nx8 drafting question
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.