Part Families for structural shapes
Part Families for structural shapes
(OP)
I have a master part file I created with a sketch of an wide flange I beam.
A spread sheet was then created using the expressions in the sketch.
The files were created in Teamcenter.
Upon opening the sketch of any of the newly created extrusion, the sketch dimensions show the correct values but the model is built to the original dimensions.
Any advice would be appreciated.
A spread sheet was then created using the expressions in the sketch.
The files were created in Teamcenter.
Upon opening the sketch of any of the newly created extrusion, the sketch dimensions show the correct values but the model is built to the original dimensions.
Any advice would be appreciated.





RE: Part Families for structural shapes
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Part Families for structural shapes
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.