×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Truss connector plates

Truss connector plates

Truss connector plates

(OP)
I am trying to determine the manufacturer of truss connector plates used in dimensional lumber roof trusses built in 1994. The only marking on the plates is 8D-4. The plates are a relatively common design, but the designation does not match any plates I am familiar with. I have contacted one manufacturer and the Truss Plate Institute so far, and they were unable to identify the plates. Anyone recognize that designation?

I should mention that one reason I am looking for information regarding these plates is that many of the plates have partially withdrawn from the wood. Some plates are cupped and some have even fully withdrawn. I have seen partially withdrawn plates many times, but never this many or this much average withdraw. One thought was defective plates, but I have seen dozens of houses in the same development and other developments built by the same builder and this is not a common condition. My thinking as of now is that it is moisture related. There was evidence of excessive moisture accumulation in the attic (stained and discolored roof sheathing).

RE: Truss connector plates

What are you going to do with that information? Might as well just add some gussets and be done with it. I have seen plates withdraw do the significant changes in wood moisture content. The shrinking and swelling supposedly can make the plates back out.

RE: Truss connector plates

(OP)
I was looking for the information for two reasons. I was curious as to whether there was some problem with these plates, which I did not really think was likely. The other reason was to obtain design data for the plates. This project has about 5 different truss designs and several are complicated designs. Measuring the trusses to come up with forces would take quite a bit of time. When I have plate details I usually determine the plate area at each member/joint and design the gussets to exceed the design values for the plates.

BTW, I did find out that the plates were made by Alpine. I contacted them and have not received a response yet.

RE: Truss connector plates

You should be able to ballpark the forces in the members pretty easily.
I think truss plates have about an 80 psi capacity. Let me know what you find out.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources