Bend
Bend
(OP)
How to create this part?:
http://i43.tinypic.com/2lt6lmt.png
in CreoElements (ProE Wildfire 5) with Bend feature?
My procedure was:
1. Create a plate of sheetmetal
2. Cutout rectangle
3. Create a flange on the inner edge of cut rectangle in chosen length
4. Unbend
5. Measure distance from unbend edge to sheetmetal plate edge
6. Edit flange - add distance to make it aligned
My point of view would be:
1. Make two rips
2. Bend ripped part
I assumed the Bend feature should be able to do this in one step.
http://i43.tinypic.com/2lt6lmt.png
in CreoElements (ProE Wildfire 5) with Bend feature?
My procedure was:
1. Create a plate of sheetmetal
2. Cutout rectangle
3. Create a flange on the inner edge of cut rectangle in chosen length
4. Unbend
5. Measure distance from unbend edge to sheetmetal plate edge
6. Edit flange - add distance to make it aligned
My point of view would be:
1. Make two rips
2. Bend ripped part
I assumed the Bend feature should be able to do this in one step.




