NX defined tool shank not displayed in Vericut
NX defined tool shank not displayed in Vericut
(OP)
We recently upgraded from NX7.5 to NX8.5 and noticed that they have added the ability to define the shank in a tool, which I really am grateful for, but we use Vericut to verfiy our programs and if a shank is defined they are not showing up in Vericut. I was wondering if anyone that also uses Verciut would know if Vericut has fixed this in an update. And if so which update? We are running Vericut 7.0.3
Thanks
Thanks





RE: NX defined tool shank not displayed in Vericut
RE: NX defined tool shank not displayed in Vericut
Mark Rief
Product Manager
Siemens PLM
RE: NX defined tool shank not displayed in Vericut
RE: NX defined tool shank not displayed in Vericut
Mark Rief
Product Manager
Siemens PLM
RE: NX defined tool shank not displayed in Vericut
"NXV is enhanced to support tapered shank in NX8 for these mill cutter types: 5 Parameters, Ball, Chamfer, and Spherical."
I have not had a chance to test this yet.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6 & NX7.5