Element distortion
Element distortion
(OP)
I get this warning message when I am doing some static coupled thermal-electrical-structural analysis and the simulation doesn't run saying too mant attempts made for this steps.
"16 elements are distorted. Either the isoparametric angles are out of the suggested limits or the triangular or tetrahedral quality measure is bad. The elements have been identified in element set WarnElemDistorted."
Any suggestion?
"16 elements are distorted. Either the isoparametric angles are out of the suggested limits or the triangular or tetrahedral quality measure is bad. The elements have been identified in element set WarnElemDistorted."
Any suggestion?





RE: Element distortion