Family Parts with different base units (mixed unit)
Family Parts with different base units (mixed unit)
(OP)
thread561-311860: Best Practice UG/NX mixed units
While using Analysis -> Units lb - in in a metric base unit file I Created a family part, Now the Spreadsheet shows dimensions in Metric.
Can I get around this by creating a table in drawing mode or is there a better way?
While using Analysis -> Units lb - in in a metric base unit file I Created a family part, Now the Spreadsheet shows dimensions in Metric.
Can I get around this by creating a table in drawing mode or is there a better way?





RE: Family Parts with different base units (mixed unit)
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Family Parts with different base units (mixed unit)
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.