Surface conception - NX7.5
Surface conception - NX7.5
(OP)
Hi,
What would be the best (most accurate) method to create a surface based on the given curves (please, see the attached NX file)?
Thanks!
What would be the best (most accurate) method to create a surface based on the given curves (please, see the attached NX file)?
Thanks!
MZ7DYJ





RE: Surface conception - NX7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Surface conception - NX7.5
MZ7DYJ
RE: Surface conception - NX7.5
Hope it helps.
Best Regards.
RE: Surface conception - NX7.5
Very nice!
I am impressed!
Thanks a lot!
MZ7DYJ