Scale down in ABAQUS
Scale down in ABAQUS
(OP)
Hello all,
I have an assembly, all meshed, properties given etc. but my problem is that the geometry is 1000 times larger than what I want (cannot change material properties because I'm doing heat transfer and stress displacement with known units).
Is there a way to scale down the geometry of my assembly?
Thank you in advance!
I have an assembly, all meshed, properties given etc. but my problem is that the geometry is 1000 times larger than what I want (cannot change material properties because I'm doing heat transfer and stress displacement with known units).
Is there a way to scale down the geometry of my assembly?
Thank you in advance!





RE: Scale down in ABAQUS
Are you new to this forum? If so, please read these FAQ:
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083