surface extend problem
surface extend problem
(OP)
Ill bet it's me but I get differing results when trying to make a surface extend in UG. Sometimes the surface extend gets dislocated and becomes disconnected. I would imagine there to be several settings there too.
1 strait extend with respect to an angle. G0
2 a G1 or tangental extend (where users can see tangent line)
3 a G2 or curvature extend (same surface no tangent line)
The other side worked fine
What can I do to extend a surface that has been swept along two or more tangent curves?
Bart brejcha training consultant http://www.designengine.com
1 strait extend with respect to an angle. G0
2 a G1 or tangental extend (where users can see tangent line)
3 a G2 or curvature extend (same surface no tangent line)
The other side worked fine
What can I do to extend a surface that has been swept along two or more tangent curves?
Bart brejcha training consultant http://www.designengine.com





RE: surface extend problem
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: surface extend problem
Tim Flater
NX Designer
NX 8.0.3.4
Win7 Pro x64 SP1
Intel Xeon 2.53 GHz 6GB RAM
NVIDIA Quadro 4000 2GB
RE: surface extend problem
Bart brejcha training consultant http://www.designengine.com
RE: surface extend problem
When in doubt, use the command finder!
www.nxjournaling.com